Taking the question as asked, rather than the general version of it. Dead space is the answer to the missing dose. A fixed-needle insulin syringe holds a few microlitres in the hub and needle after the plunger bottoms out, and on small draws that is a measurable percentage of every dose. Across ten draws it adds up to most of an eleventh, which is exactly the "nine draws from a ten-dose vial" complaint. Luer-lock syringes are worse; low-dead-space fixed-needle designs are better.

Dr.CardioMD said:

Dead space is the answer to the missing dose.

No disagreement with Dr.CardioMD. One condition attached. The arithmetic is right and one caveat matters: a U-40 syringe changes the markings, not the volumes. If someone hands you U-40 and you read it as U-100 you will be 2.5 times out, and that error has a direction — it is always an overdose.

Dr.NateNeph said:

I reconstituted a 10mg vial with 2ml of bacteriostatic water and I want someone to check my unit arithmetic before I draw anything, because I keep…

Can confirm the pattern Dr.NateNeph describes. Do it in two steps and it stops being confusing. First concentration: 10mg into 2ml is 5mg/ml. Then volume: a 0.5mg dose is 0.5 ÷ 5 = 0.1ml. Then units, and this is where people go wrong — a U-100 syringe is graduated in hundredths of a millilitre, so 0.1ml is 10 units. The word "units" has nothing to do with milligrams; it is a volume marking that exists because insulin happens to come at 100 units per ml.

From the other side of the consultation, briefly.

Quick syringe math for dosing arithmetic dosing: if your vial is reconstituted at 5mg/2mL, that's 2.5mg/mL. For a 0.25mg dose you need 0.1mL = 10 units on an insulin syringe.

I keep a chart on my fridge:

• 0.25mg = 10 units
• 0.5mg = 20 units
• 1.0mg = 40 units
• 1.25mg = 50 units

Always double-check your concentration before drawing up!